I have omron PLC in my machine. Model: CP1H.
I have bought a new one for spare the PLC.
So, I have uploaded the software from old one through CX-One software and downloaded to new one.
Everything work fine with new PLC but one Solenoid valve is not working. I have tried many ways. I have again install old one it's fully working but when I install new one with same program only that particular solenoid valve is not working.
My both PLC are looking 100% same and the program also 100% same.
Can anyone suggest me where is the problem?
( I have attached my program here.
Program download link: https://www.dropbox.com/s/utff8db93roxv ... H.zip?dl=0
For program: line 52 and 53 output: 101.00 and 101.01
is responsible for the solenoid coil that's not working properly)
