[?]: AB Ultra 3000 and Logix5563

RSLinx, RSLogix, RSView, LogixPro ...
Post Reply
dzwilu
Posts: 2
Joined: Wed Jun 17, 2009 10:22 am
Location: Europe

[?]: AB Ultra 3000 and Logix5563

Post by dzwilu » Fri Jul 10, 2009 1:37 pm

Hi,
I have a problem with a Ultra 3000 servo.
I communicate my Logix5563 via the sercos interface.
The communication works fine - the network status LED is solid green.
The problem is the module status LED is blinking, which means drive locally disabled.
How can I enable the drive??
I haven't got any configuration errors. While entering the axis properties and choosing the hookup tab, I try to test the drive.
But then a dialog appears: Drive is locally disabled.
I went through a few manuals and I have absolutely no idea how to enable the drive...
Any ideas/support etc?

Best regards
dzwilu

dehell
Posts: 104
Joined: Sat Jun 13, 2009 12:25 pm
Location: Europe

Post by dehell » Sun Jul 12, 2009 7:28 pm

Hi
I don't know sercos interface.
But on devicenet network, you have to enable your ULTRA3000.
On DeviceNet there is two way for enable your ULTRA 3000 :
by software (in RSLogix 5000 : you have to enable a bit). This bit has defined by chosing your command mask.
by hardware : in Utraware software, select an input has "enable input" then connect an PLC output to this input.
So, by programming your plc you can enable or not your ULTRA 3000.
I hope it will help you.

bmller6758
Posts: 4
Joined: Sun Jun 08, 2008 12:54 pm
Location: Europe

Post by bmller6758 » Thu Jul 16, 2009 8:37 pm

Image

jscumm
Posts: 33
Joined: Tue Apr 28, 2009 6:17 pm
Location: America

Re: [?]: AB Ultra 3000 and Logix5563

Post by jscumm » Thu Jul 23, 2009 6:52 pm

dzwilu wrote:Hi,
I have a problem with a Ultra 3000 servo
email me as an acknowledgement, i will send you an example with complete explanation

Post Reply