I have issue of ground fault on the drive powerflex 755 110kw , i check motor terminals, megger it found that greater than 220 MOHM resistance in all winding to earth , that ground fault followed by HW overcurrent fault occur once in a while in day during running , sometimes it reset through drive HMI red button sometimes it not reset with it then i have recycle the power then it clears ,
what may be the issue?
also
Can I run powerflex 755 drive without motor load for 1 day ? so that if fault comes then we sure that its from drive itself , is there any problem with drive if you run drive without load for 1 day ?
I really appreciate your help
powertflex 755
Jump to
- International User Forum
- ↳ SIMATIC Automation
- ↳ SIMATIC system
- ↳ Utilites for Simatic PLC
- ↳ Siemens SIMATIC HMI
- ↳ SIMATIC HMI
- ↳ Utilites For simatic HMI
- ↳ OMRON
- ↳ OMRON PLC & HMI
- ↳ Utilites
- ↳ Allen-Bradley
- ↳ Allen-Bradley (Rockwell Automation)
- ↳ Utilites
- ↳ other PLC
- ↳ Other PLC
- ↳ Utilites
- ↳ Other HMI
- ↳ Other HMI
- ↳ Utilites
- ↳ Drivers and Inverters
- ↳ Sensors
- ↳ Industrial network
- ↳ samples
- ↳ Siemens Hardware & Software
- ↳ PLC`s Videos/Audios/Books & Over Manuals
- ↳ PLC's video
- ↳ PLC's books
- ↳ Other Books
- Russian User Forum in Russian
- ↳ Simatic (Russian)
- ↳ Simatic HMI (Russian)
- ↳ Other PLC and HMI (Russian)
- The Near-PLC Themes
- ↳ About forum , files exchangers and RULES
- ↳ Other (only about CAD and Soft)
- ↳ JOB