[?]: Password for ProTool Touchsreen

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
purgaxo
Posts: 2
Joined: Wed Oct 17, 2007 9:30 pm

[?]: Password for ProTool Touchsreen

Post by purgaxo » Wed Oct 17, 2007 9:49 pm

Hello!
I have a problem.
I forgot password for Touchsreen at BetoneMachine.
I have a SystemBackup.

Can anybody help?

alfred.eekhoorn
Posts: 1
Joined: Fri Oct 19, 2007 6:12 pm
Location: Europe

Post by alfred.eekhoorn » Fri Oct 19, 2007 6:13 pm

On some Simatic Touch HMI's the system password is 4545

reymond_craig
Posts: 139
Joined: Wed Sep 26, 2007 2:57 am
Location: Philippines

Post by reymond_craig » Mon Oct 22, 2007 12:46 am

Hi,
The default password for Touchscreen MP370 is 100, if you are sure you have the existing downloaded program, you can take a look at first open your protool project then go to system - settings you can see what is the OP supervisor password. Try to used this password when you are promted on the touchscreen.

Hope this can help.

Warm regards,
Rey

dante
Posts: 48
Joined: Fri Oct 19, 2007 6:35 am
Location: romania

Post by dante » Tue Oct 23, 2007 11:11 am

what TP do you have?
The pass is the one set on the ProTool project; the default value for this pass is 100 that means after a project download, the level 9 pass is 100; after this, you can change the pass from the TP and the old one is no longer valid.
If U loose that pass, the way to get the control back is to download again the project. To get into the download menu U must swich off the supply of the TP, the transfer button appears for short time after restoring the power. Note that downloading the project again will loose the receipes.