How to monitor for the operator actions ?

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
Alex3110
Posts: 159
Joined: Mon Sep 27, 2010 7:17 pm

How to monitor for the operator actions ?

Post by Alex3110 » Wed Aug 10, 2016 5:04 am

Hello everybody !

I need to monitor for the operator actions at an Operator Station with WinCC v.7.0 and to get the corresponding messages in "Alarm Logging Screen" in Runtime when an operator :
1. Press any button that can be pressed at any screen

Is it possible to use "Operator Input Message" feature or I need to use something else ?
How can I do it ?

Where and how can I write my comment texts (e.g. “Valve VA1 control. A “Open” button” was pressed”) in order they to appear as message texts in "Alarm Logging Screen" in Runtime when operator makes above mentioned action ?

Thanks in advance.

Marrenoloth
Posts: 62
Joined: Tue Dec 22, 2009 12:45 am
Location: Москва

Re: How to monitor for the operator actions ?

Post by Marrenoloth » Wed Aug 10, 2016 5:18 am

Don't know about "monitoring" but about operator actions logging in WinCC here: http://asutpforum.ru/viewtopic.php?f=157&t=7535
Unfortunaly, on russian.

Alex3110
Posts: 159
Joined: Mon Sep 27, 2010 7:17 pm

Re: How to monitor for the operator actions ?

Post by Alex3110 » Tue Aug 16, 2016 3:33 pm

Спасибо. Случай оказался не шибко сложным, сам разобрался.
На кнопке (ках) оказалась незадействована опция "Release Left" для клацанья мыша по ней. Ну вот я её и использовал. Когда опер, нажимая кнопку, посылыает к/л команду на ИМ, то для этого используется уже ранее сконфигуированая опция "Press Left".
Если бы опция "Release Left" была также задействована, то пришлось бы плясать с бубном дальше и дольше :D

Post Reply