Hello Every One ...
Does any one know how to Connect a ABB AC800F Controller To WinCC SCADA System Using OPC .. ??
and if any one have a training course for the OPC ..
thanks every one ...
Connecting ABB AC800F Controller To Simatic WinCC Prof
-
Eng-Hunter
- Posts: 1
- Joined: Sat Feb 22, 2014 8:00 am
Re: Connecting ABB AC800F Controller To Simatic WinCC Prof
use modbus TCP communication (sorry AC800F support Modbus TCP)
Other solutions (additional communication modules) : below refer sites (ABB)
----------------------------------------------------------------------------------
1. PROFIBUS
2. FOUNDATION
3. MODBUS (master / slave, RTU or ASCII)
4. IEC 60870-5-101, IEC 60870-5-104
5. CAN
Refer site
------------
https://new.abb.com/control-systems/ess ... ler/ac800f
Other solutions (additional communication modules) : below refer sites (ABB)
----------------------------------------------------------------------------------
1. PROFIBUS
2. FOUNDATION
3. MODBUS (master / slave, RTU or ASCII)
4. IEC 60870-5-101, IEC 60870-5-104
5. CAN
Refer site
------------
https://new.abb.com/control-systems/ess ... ler/ac800f
Last edited by kukuris on Sat Feb 01, 2020 10:36 am, edited 2 times in total.
-
Answers to FAQs
- Faq & Info
- Posts: 173
- Joined: Thu Oct 13, 2005 6:42 pm
- Location: Frequently Asked Questions – Часто Задаваемые Вопросы
Re: Connecting ABB AC800F Controller To Simatic WinCC Prof
you can use s7-1211+cb485 as Modbus gateway