PLC resouce monitoring

Utilites for Simatic Automation
Post Reply
bazilio
Posts: 2
Joined: Tue Jul 23, 2013 10:06 pm

PLC resouce monitoring

Post by bazilio » Sat Aug 19, 2017 12:39 pm

Hi! I am looking SW for PLC resource monitoring: state (RUN/STOP), cycle time, memory use/free, communication, etc. Archiving and messaging is desirable.
p.s. VersionDog already in use.

cacapone
Posts: 16
Joined: Fri Jul 09, 2010 2:35 pm

Re: PLC resouce monitoring

Post by cacapone » Wed Aug 23, 2017 8:58 am

if your PLC can, Website give a lot of informations

sowieso1977
Posts: 10
Joined: Sat Feb 21, 2009 1:54 pm
Location: Europe

Re: PLC resouce monitoring

Post by sowieso1977 » Mon Sep 04, 2017 9:38 am

Hi all

Did you have this one
https://www.versiondog.com/versiondog_f ... tatus.html?

Best regards,
sowieso

sowieso1977
Posts: 10
Joined: Sat Feb 21, 2009 1:54 pm
Location: Europe

Re: PLC resouce monitoring

Post by sowieso1977 » Sun Jan 21, 2018 4:23 pm

SIMATIC Automation Tool
----------------------------------
After a control program is created and verified with the Siemens TIA Portal software, the SIMATIC Automation Tool can be used in the field for operating and maintaining SIMATIC S7-1200, S7-1500, ET 200, HMI, SITOP, RFID and MOBY Ident modules.

Automation Tool operations:

Scan an PROFINET/Ethernet network and identify all devices connected to the network
Flash device LEDs or HMI screens to physically locate a device
Create a table that maps the accessible devices on the network
Assign addresses (IP, subnet, gateway) and station name (PROFINET device)
Set the time in a CPU to the current time in your PG/PC
Download a program to a CPU (support failsafe programs needs at least V3.1) and HMI panels
Put a CPU in RUN or STOP mode
Perform a CPU Memory reset

Backup/Restore CPU or HMI data to/from a backup file (failsafe needs at least V3.1)
Upload service data from a CPU
Read the diagnostic log from a CPU
Reset a CPU to factory default settings
Update firmware in a CPU and attached modules
Upload, download, or delete Recipe data (stored at SMC) from a CPU
Upload or delete Data log data (stored at SMC) from a CPU
Document and save your network information
in a standard text .csv file or
an encrypted & password protected .sat file
API support to create custom applications based on the functionality available in the SIMATIC Automation Tool

All named features can operate in parallel to various CPUs.

Post Reply