From Siemens to Mitsubishi

другие контроллеры
Post Reply
Pavel745
Posts: 1
Joined: Wed Sep 23, 2015 5:58 am

From Siemens to Mitsubishi

Post by Pavel745 » Fri Aug 30, 2019 7:03 am

Hello Friends!!!

I'm currently getting started automation project based on the FX5 Mitsubishi PLC (It's too much difficulty after 10 years working with Siemens).

I already had installed "GX Works3" software and download necessary documentation. Now I try to configure PLC hardware in "GX Works" according to my requirements. Everything was clear until setting the "FX5-CNV-IFC" module. I can't find this module (FX5-CNV-IFC) in an "Element selection" catalog. (h) (h) (h)
Maybe, (I suppose) it is need to install some additional hardware support package (same as "Hardware update" in Siemens)? But which exactly?

My question is how to added necessary hardware (in my case "FX5-CNV-IFC") in hardware catalog?

Thanks a lot.

Post Reply