PLCforum.uz.ua

Posted: **Mon Apr 16, 2018 8:56 am**

hello everyone
we work on a water station using plc schneider M340 and we should make a communication with a dcs honeywell , this dcs should read a variables from my plc i have a ethernet module BMX NOE 0.100
i put the ip adress but the dcs show that the variables are not online

Posted: **Mon Apr 16, 2018 2:52 pm**

Hi accmpy,

on M340 side you can only setup the IP-address and %MWi variable addresses.
So, if communication doesn't work, then check the IP and %MWi addresses.

PLCforum.uz.ua

Urgent communication between Schneider m340 and honeywell

Urgent communication between Schneider m340 and honeywell

Re: Urgent communication between Schneider m340 and honeywel