Page 1 of 1
ABB AC800C - I need to edit a program
Posted: Fri Jan 17, 2014 12:09 pm
by rafaesc
Hi everybody¡¡
I need to edit a project from a AC800C PLC, I have got the backup and I have read that the needed software version is 3.2 of Control Builder M.
Is possible to have a copy of this version? Any idea?
For me, it's enough with a PDF list of the code of this program (at least by now)
Thanks
Re: ABB AC800C - I need to edit a program
Posted: Thu Jan 23, 2014 11:23 am
by Linkinx64
Re: ABB AC800C - I need to edit a program
Posted: Thu Jan 23, 2014 12:44 pm
by rafaesc
Hi Linkinx64,
Thank you for the files but aren't a valid software, it seems to be an "optimizer" software or something like that......
Re: ABB AC800C - I need to edit a program
Posted: Thu Jan 23, 2014 2:51 pm
by Linkinx64
rafaesc wrote:I have read that the needed software version is 3.2 of Control Builder M.
..so I gave you a Control Builder M v3.2. This software is for edit AC 800M/C projects. Check the 2nd folder inside the archive.
Re: ABB AC800C - I need to edit a program
Posted: Thu Jan 23, 2014 4:37 pm
by rafaesc
Hi again
I've downloaded three rar files but when i try to unzip, the software says "unknown format or file damaged".
The three files are 13KB, I think it's too small....
Thanks
Re: ABB AC800C - I need to edit a program
Posted: Thu Jan 23, 2014 5:01 pm
by Linkinx64
Full size is ~ 578 Mb. 13 Kb can't fit "Hello, world!" application even. Try download again.
Re: ABB AC800C - I need to edit a program
Posted: Sat Jan 25, 2014 6:22 pm
by rafaesc
Thank you very, very, very........,very much
As you said, the files and the software are OK......my problem was not uncheck the FileFactory Download Manager....
Now, I can convert this code into Step7...
Thank You again....