Page 1 of 1
Request: Dox10 3.4 for Sattcon 200 Series from ABB
Posted: Thu May 28, 2009 6:10 am
by Elahe
Hi Friends
I am working on Sattcon 200 Series from ABB .
anyone can share me dox10 with new vesion such as 3.4 ?
Thanks
Re: Request: Dox10 3.4 for Sattcon 200 Series from ABB
Posted: Tue Mar 18, 2014 8:25 pm
by drzewiec
Good day,
I am also looking DOX10 3.4-0 for a long time, could somebody share it?
WBR, Drzewiec
Re: Request: Dox10 3.4 for Sattcon 200 Series from ABB
Posted: Tue Mar 18, 2014 10:26 pm
by Carlos
A few years ago I tried to connect with Sattcon controller but without success.
http://www.cnczone.com/forums/general-c ... -need.html
password ADM is dox10
serial cable
2-3
3-2
5-7
other information by Sattcon:
....... your cable configuration is correct. you can power off and hold shift button and then power up, this will restart but you must have backup and cable to upload backup after restart.
We also convert any SATTCON PLC to AC800M (ABB) or S7 (siemens)...........
Carlos
Re: Request: Dox10 3.4 for Sattcon 200 Series from ABB
Posted: Wed Mar 19, 2014 3:19 pm
by Turkey4VM
Cable for sattcon 200: I did it by my self. Works fine. But it is need a native com port in your pc, any adapters usb-to-com doesn't work.
