Control Schneider Sepam S40 via Modbus RTU
Posted: Wed Nov 09, 2016 11:21 am
Hello,
I have the following problem: when I send TC1 Tripping (command bit for activating tripping) binary output O1 does not close and nothing happens. In the manual for the S40 is written that this is possible. I am successfully switching setting groups and resetting, so I don't think this is communication problem. I tried two ways - with S7 1200 PLC and with KEPServerEX V5. Could You help me, please?
This is link to the manual: http://powerlogic.com/literature/63230-216-219-B1.pdf
Best regards!
I have the following problem: when I send TC1 Tripping (command bit for activating tripping) binary output O1 does not close and nothing happens. In the manual for the S40 is written that this is possible. I am successfully switching setting groups and resetting, so I don't think this is communication problem. I tried two ways - with S7 1200 PLC and with KEPServerEX V5. Could You help me, please?
This is link to the manual: http://powerlogic.com/literature/63230-216-219-B1.pdf
Best regards!