PLCforum.uz.ua

HI
Personal of the forum I am the search of the MR configurator Mitsubishi

thank
flopez

please erase this post

Thank you MOST
i am going to download it now

thanks again its people like you that make this superb forum what it is 100% brilliant

I am looking for MR Configurator for MR-H350A drive. Can anybody help?

Hi all.

From the other links I have downloaded/ installed MR Configurator 81E, 161E, 221EVB1

81E, 161E went OK, but I never worked with them and for some reason on File tab Open, Save and Print are greyed out.

I would like to play with the parameters to see how they look like.

On 221E they are asking for an ID number.

Does anyone has it for sharing?

Kind Regards
Jamrobe

jamrobe wrote:Hi all.
On 221E they are asking for an ID number.
Jamrobe

see the file in the http://plc.net.ru/viewtopic.php?t=8252
this 221E not need serial (for MR-J3-A e para MR-J3-B )
if you want install 221EVB1 (for MR-J3-T, MR-J3-B Linear e MR-J3-Fully Close) changes the file "setup.inx" of Setup221E for Setup221EVB1 and install.
221EVB1 functions as update of the 221E
or test this file Link_is_Dead :(/s ... x.Link_is_Dead :(

most

Thanks a lot most

Now it is working, I tested and is OK.

However for 161E on file all menus Open,Save,Print are greyed out.
Do you know the reason for it?
It is because it's working only online?

Regards
Jam

jamrobe wrote: However for 161E on file all menus Open,Save,Print are greyed out.
Do you know the reason for it?
It is because it's working only online?

first open menu parameters ...parameters list ...
for example: loads the values for defect (set to default)
now you can save, print ....

regards

Thousands thanks most.

Works perfect.

My regards to you and all our buddies on forum
Jam