Danfoss VLT 5000 crane
Posted: Wed Nov 26, 2014 8:49 pm
Dear All
I have Danfoss VLT 5000 crane driver when I operate it the ALARM[44] (Encoder fault) (Alarm LED flashing red) occurred but I didnot use encoder therefore:-
I goto parameter 650 and change protection level to (Level 1: Commissioning)by entering 110775 as a password, then I tried to change parameter 100 to (SPEED OPEN LOOP) but I can not even when parameter 18 is set to (NOT LOCKED)
what can I do to
1- Reset alarm or cancel it?
2- Change parameter 100 to (SPEED OPEN LOOP)?
Thanks
I have Danfoss VLT 5000 crane driver when I operate it the ALARM[44] (Encoder fault) (Alarm LED flashing red) occurred but I didnot use encoder therefore:-
I goto parameter 650 and change protection level to (Level 1: Commissioning)by entering 110775 as a password, then I tried to change parameter 100 to (SPEED OPEN LOOP) but I can not even when parameter 18 is set to (NOT LOCKED)
what can I do to
1- Reset alarm or cancel it?
2- Change parameter 100 to (SPEED OPEN LOOP)?
Thanks