drive control technique uni1405

привода и частотники
Post Reply
Posts: 26
Joined: Tue Apr 13, 2010 11:21 pm

drive control technique uni1405

Post by mario_ingen » Sun Mar 10, 2013 11:57 pm

Hello Dear.
again asking for support, I have to migrate a computer controlling technique emerson drive uni1405 model,
is an older model and has a profibus card too old.
The problem in the profibus card has a small program that I can not download and I have to edit in order to pass the new emerson servo I'll post.

new servos comes in a card that Annex and there I write the program or routine that takes ...

anyone have any idea how to download that program profibus card

Posts: 4
Joined: Fri Nov 12, 2010 6:28 pm

Re: drive control technique uni1405

Post by DSR1 » Sat Apr 06, 2013 10:38 am

I don't be sure if you are talking about unidrive SP(New) or unidrive V3,VTC, etc.. (Old).
I think both no have program in this card.
The card has to be parametrized in expansion menu (15,16,17) depends where you fit the card, this way is for SP I don't remerber for the other.
The program in Unidrive is in the SM Applications, (SP) or UD70 (V3).
Normaly when you do the program, you parametrized the card in the program.

Posts: 34
Joined: Mon Oct 11, 2010 12:54 pm

Re: drive control technique uni1405

Post by peterc101 » Sat Apr 06, 2013 3:04 pm

go to control techniques site

as i remember softwares are free to download , after free registration
you need software to download profibusparameters to the SM-module profibus

Posts: 3
Joined: Wed May 30, 2012 9:17 am

Re: drive control technique uni1405

Post by Yougi » Wed Apr 17, 2013 12:14 pm

if you need only to read profibus parameters from UD73 module you could do it simply from drive display - this is #20.1 to #20.7 parameter values.
if you need to read program from the module, download and register Sypt software packet from CT web page.
But there is no useful results for you, cose profibus in Uni V3 and Uni Sp are absolutely different - cw and sw are not compatible, parameter assignment too.
And, if you want to use servo control tricks from V3 to SP - no way, they are different same.
From my side I would recommend write all stuff from the very beginning.

Post Reply