[?]: pin out for cable of drive monitor 5.4 and simovert

привода и частотники
Post Reply
maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

[?]: pin out for cable of drive monitor 5.4 and simovert

Post by maher » Mon Jun 07, 2010 2:13 pm

Hi all
i have the ( drive monitor 5.4 sp1 ) software and i need the specification for the communication cable between simovert drive and my copmuter .

also i need the procedures to upload the parameters from the drive & the steps to download the parameters to the drives


best regards

MAHER

venix
Posts: 122
Joined: Fri Feb 29, 2008 4:17 pm
Location: Europe

Re: [?]: pin out for cable of drive monitor 5.4 and simovert

Post by venix » Tue Jun 08, 2010 1:07 pm

Hello!

The cable is a DB9 male(Simovert) - DB9 Female(computer)
pin8 - pin 2
pin2 - pin 3
pin 5- pin 5
chassis ground- chassis ground

Best regards!
Venix

maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

Re: [?]: pin out for cable of drive monitor 5.4 and simovert

Post by maher » Sat Aug 28, 2010 11:00 pm

Hallo

i need the pin out also for the connection between the PC & MASTERDRIVE MC

regards
Maher

Umencho
Posts: 497
Joined: Mon Jul 16, 2007 12:28 pm
Location: Europe

Re: [?]: pin out for cable of drive monitor 5.4 and simovert

Post by Umencho » Sun Aug 29, 2010 6:07 pm

Hello Maher,

You could find pin's description in MC Compendium.
( http://support.automation.siemens.com/W ... n/13472407 ).
Basically cables are the same with VC.

BR

Post Reply