[?]: cable to upload parameters on Micromaster

Luca_Brasi · Post by **Luca_Brasi** » Fri Sep 18, 2009 4:20 pm

Hi all
anybody have a sch on cable for connect PC to Siemens Micromaster inverter (for upload a parameters) I have a OP, but this is very lazy work thanks!

Umencho · Post by **Umencho** » Sat Sep 19, 2009 3:29 am

Hello,

You have to Purchase a PC inverter kit (6SE6400-1PC00-0AA0) to use RS232 port of drive, or you can use terminal 29 and 30 on I/O module But then you will required a RS 485 to RS 232 converter.
Look at https://www.automation.siemens.com/WW/f ... anguage=en .
This converter also protect your PC from possible damage.

Hope this will helps.

Regards

Luca_Brasi · Post by **Luca_Brasi** » Sat Sep 19, 2009 7:53 am

I find this sch for RS 485 to RS 232:
http://aquaticus.info/files/RS485%20to% ... ematic.png
This week i will make this and report result

crack_x01 · Post by **crack_x01** » Wed Sep 23, 2009 7:24 am

Luca_Brasi wrote:I find this sch for RS 485 to RS 232:
http://aquaticus.info/files/RS485%20to% ... ematic.png
This week i will make this and report result

What is the voltage Vcc?

regard

most · Post by **most** » Wed Sep 23, 2009 8:13 am

crack_x01 wrote: What is the voltage Vcc?
regard

7805 = 5 V

about rs232/485
some projects and link in http://www.edaboard.com/ftopic71311.html
(need register)

Pokajy · Post by **Pokajy** » Mon Sep 13, 2010 11:24 pm

I'm using this:

PLCforum.uz.ua

[?]: cable to upload parameters on Micromaster

[?]: cable to upload parameters on Micromaster

Re: [?]: cable to upload parameters on Micromaster