[?]: Lenze servo drive 9300 parameters

привода и частотники
Post Reply
maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

[?]: Lenze servo drive 9300 parameters

Post by maher » Wed Jul 08, 2009 8:13 pm

Hi all
i am trying to find any information to illustrate the whole of parameters of this type of lenze drive

i need to use servo lenze drive 9300 to make a homing for the motor

how can i do it ?
best regards

MAHER
Top
maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

Post by maher » Thu Jul 09, 2009 7:24 pm

what can i do?

i am disappoint about this drive

MAHER
Top
EuGrach
Posts: 41
Joined: Mon Dec 01, 2008 2:40 am
Location: Russia

Post by EuGrach » Fri Jul 10, 2009 1:12 am

Technical documentation:
http://www.lenze.com/downloadbereich/en/_start.htm

Software:
http://www.lenze.com/lenze.com_en_activ ... h=download

I am use "Global Drive Control" PC software for easy commissioning of Global Drive frequency inverters
Top
taube
Posts: 1
Joined: Fri Feb 12, 2010 7:41 am

Re:

Post by taube » Fri Feb 12, 2010 7:48 am

EuGrach wrote:Technical documentation:
http://www.lenze.com/downloadbereich/en/_start.htm

Software:
http://www.lenze.com/lenze.com_en_activ ... h=download

I am use "Global Drive Control" PC software for easy commissioning of Global Drive frequency inverters
how you connect pc to servo?
Top
sventek
Posts: 56
Joined: Sun Jul 13, 2008 10:48 am
Location: Europe

Re: [?]: Lenze servo drive 9300 parameters

Post by sventek » Fri Feb 19, 2010 10:50 am

Hi!

Either you use LECOM A/B or CAN interface. Both are distributed only by Lenze.

Greetings
sventek
Top
EuGrach
Posts: 41
Joined: Mon Dec 01, 2008 2:40 am
Location: Russia

Re: Re:

Post by EuGrach » Sat Feb 20, 2010 10:36 pm

taube wrote: how you connect pc to servo?
using Lecom module:

Image
Image
Top
Post Reply

Return to “Drivers and Inverters”