Hi,
I am upgrading a AB PLc to Siemens PLC logic and everything is ready for siemens but the problem is the existing PLC is communicating to DCS via modbus RTU as slave.
I can see some alarms and data from N10:0 register moving to M0:1.1 with a length of 50 file and from DCS M1:1.1 data moving to register N10:22 with a length of 1.
I wish to know the modbus address of this is it like N10:0=40001 and N10:22 = 400022 ?? as I need to do the same in siemens PLC with the help of modbus module
Regards
Sandy
1746 BAS 502 M0/M1 module
RSLinx, RSLogix, RSView, LogixPro ...
-
- Posts: 32
- Joined: Thu Dec 18, 2014 4:52 pm
Return to “Allen-Bradley (Rockwell Automation)”
Jump to
- International User Forum
- ↳ SIMATIC Automation
- ↳ SIMATIC system
- ↳ Utilites for Simatic PLC
- ↳ Siemens SIMATIC HMI
- ↳ SIMATIC HMI
- ↳ Utilites For simatic HMI
- ↳ OMRON
- ↳ OMRON PLC & HMI
- ↳ Utilites
- ↳ Allen-Bradley
- ↳ Allen-Bradley (Rockwell Automation)
- ↳ Utilites
- ↳ other PLC
- ↳ Other PLC
- ↳ Utilites
- ↳ Other HMI
- ↳ Other HMI
- ↳ Utilites
- ↳ Drivers and Inverters
- ↳ Sensors
- ↳ Industrial network
- ↳ samples
- ↳ Siemens Hardware & Software
- ↳ PLC`s Videos/Audios/Books & Over Manuals
- ↳ PLC's video
- ↳ PLC's books
- ↳ Other Books
- Russian User Forum in Russian
- ↳ Simatic (Russian)
- ↳ Simatic HMI (Russian)
- ↳ Other PLC and HMI (Russian)
- The Near-PLC Themes
- ↳ About forum , files exchangers and RULES
- ↳ Other (only about CAD and Soft)
- ↳ JOB