Hi,everybody!
I have a problem when working with rsview32.After turning off the light the system(windows was shut down), the settings for displaying charts(trend) were lost. I found out that displaying the graph by X now is 30 minutes(Time span), and in order to display it correctly, it should take 30-60 seconds. The situation is similar with the Y-axis. But now the problem is that when you set the correct values for displaying parameters for Y And X and then close the program, everything is reset(Stop Project). Is it possible to save these values somehow so that they are not reset when the program is closed?
PM:Sorry for my ebglish
Problem with rsview32
RSLinx, RSLogix, RSView, LogixPro ...
Return to “Allen-Bradley (Rockwell Automation)”
Jump to
- International User Forum
- ↳ SIMATIC Automation
- ↳ SIMATIC system
- ↳ Utilites for Simatic PLC
- ↳ Siemens SIMATIC HMI
- ↳ SIMATIC HMI
- ↳ Utilites For simatic HMI
- ↳ OMRON
- ↳ OMRON PLC & HMI
- ↳ Utilites
- ↳ Allen-Bradley
- ↳ Allen-Bradley (Rockwell Automation)
- ↳ Utilites
- ↳ other PLC
- ↳ Other PLC
- ↳ Utilites
- ↳ Other HMI
- ↳ Other HMI
- ↳ Utilites
- ↳ Drivers and Inverters
- ↳ Sensors
- ↳ Industrial network
- ↳ samples
- ↳ Siemens Hardware & Software
- ↳ PLC`s Videos/Audios/Books & Over Manuals
- ↳ PLC's video
- ↳ PLC's books
- ↳ Other Books
- Russian User Forum in Russian
- ↳ Simatic (Russian)
- ↳ Simatic HMI (Russian)
- ↳ Other PLC and HMI (Russian)
- The Near-PLC Themes
- ↳ About forum , files exchangers and RULES
- ↳ Other (only about CAD and Soft)
- ↳ JOB