[?]: Rotary Servo Homing RSlogix 5000

RSLinx, RSLogix, RSView, LogixPro ...
Post Reply
plavyuk
Posts: 7
Joined: Fri Feb 11, 2011 11:30 pm

[?]: Rotary Servo Homing RSlogix 5000

Post by plavyuk » Wed Sep 28, 2011 12:55 pm

Hi to All. Looking for advise how to do the homing for MultiTurn Rotary Servo Drive, im using Compact Logix L43, Kinetix 6000. Thanks.

hussein kamal
Posts: 39
Joined: Thu Jul 29, 2010 7:51 am

Re: [?]: Rotary Servo Homing RSlogix 5000

Post by hussein kamal » Wed Oct 05, 2011 5:51 pm

hi plavyuk
i see that idea in machine you can using small sensor to know it homing position but i don't know how in program but i see it in some application

Dan_Andric
Posts: 4
Joined: Thu May 05, 2011 2:33 pm

Re: [?]: Rotary Servo Homing RSlogix 5000

Post by Dan_Andric » Wed Oct 12, 2011 2:38 am

it all depends to what you set up the option of homing to be, there is to home
- To Sensor/Fwd to Marker
- To Sensor/Back to Marker
- Home to Marker
- Home to Current Value/Back to Marker
- Home to Current Value
- Home Sensor

plavyuk
Posts: 7
Joined: Fri Feb 11, 2011 11:30 pm

Re: [?]: Rotary Servo Homing RSlogix 5000

Post by plavyuk » Tue Jan 31, 2012 2:35 pm

Thanks to all. I use the homing sensor.

TMS320F2812
Posts: 6
Joined: Sat Sep 24, 2011 10:43 am

Re: [?]: Rotary Servo Homing RSlogix 5000

Post by TMS320F2812 » Wed Feb 01, 2012 10:08 am

You Must to configure axis at Tab Home after you have add axis it to RSlogix5000 project.
After that you have select following your assignment it depend on sensor similar prevoius reply to you.

Post Reply