Page 1 of 1

[?]: MSG Instruction Help

Posted: Fri Jul 29, 2011 8:58 am
by cuongvcs
I have a small problem.
I have 1 SLC 1747-L553C and 1 controllogix Controller .This PLC communication through ErtherNet.
Help me how to write the communication between them through ErtherNet.
If you can give me some specific examples, the better the guide.
thank and best regards. (sos) (sos) (sos)

Re: [?]: MSG Instruction Help

Posted: Fri Jul 29, 2011 5:55 pm
by Ryzhij
Do you have the Logix5000 Controllers Messages Programming Manual (in English) or same manual in Russian ? (dlink)
Also the SLC 500 Ethernet Quick Start (in English) may be help you.

Re: [?]: MSG Instruction Help

Posted: Sat Jul 30, 2011 7:24 am
by hai_api
Hi Ryzhij !
I try to do follow in manual but sitll can't .
the MSG intruction in my program only with control block lenght 14 , with ethernet it must be 51 .
i do all ways but still not. (h)
and in Target device only have 500CPU / 485CIF / PLC5 / MODBUS , no more but i wanna to send massage to control logix PLC (how can I do ?)
Same with this in RS logix 5000
now i use Rs logix 500 V8.4
please help me.
Can they communication or not?????? :shock: :shock: :shock:

Re: [?]: MSG Instruction Help

Posted: Sat Jul 30, 2011 11:05 am
by Ryzhij
Tray read this discussion also http://forums.mrplc.com/index.php?act=ST&f=1&t=14976
I hope it can help you

PS: Sorry, but my Tec-connect numbers is absolved now

Re: [?]: MSG Instruction Help

Posted: Mon Aug 01, 2011 1:21 am
by cuongvcs
You can give me some specific examples .
thank a lot.