[?]: AB Ultra 3000 and Logix5563
Posted: Fri Jul 10, 2009 1:37 pm
Hi,
I have a problem with a Ultra 3000 servo.
I communicate my Logix5563 via the sercos interface.
The communication works fine - the network status LED is solid green.
The problem is the module status LED is blinking, which means drive locally disabled.
How can I enable the drive??
I haven't got any configuration errors. While entering the axis properties and choosing the hookup tab, I try to test the drive.
But then a dialog appears: Drive is locally disabled.
I went through a few manuals and I have absolutely no idea how to enable the drive...
Any ideas/support etc?
Best regards
dzwilu
I have a problem with a Ultra 3000 servo.
I communicate my Logix5563 via the sercos interface.
The communication works fine - the network status LED is solid green.
The problem is the module status LED is blinking, which means drive locally disabled.
How can I enable the drive??
I haven't got any configuration errors. While entering the axis properties and choosing the hookup tab, I try to test the drive.
But then a dialog appears: Drive is locally disabled.
I went through a few manuals and I have absolutely no idea how to enable the drive...
Any ideas/support etc?
Best regards
dzwilu