[?]: Config VIPA in Step7

alexSl · Post by **alexSl** » Tue Jan 29, 2008 2:36 pm

How config analog input of VIPA 314ST in STEP 7 5.3 SP3 ?

in Russian wrote:Возникли проблемы при конфигурировании VIPA 314ST STEP 7 5.3 SP3, gsd файлы версии 1.80 .
Не получается сконфигурировать встроенные аналоговые входа на измерение тока. Хотя напряжение меряют.
И еще: на фирме, где брали, говорят, что все нормально.
У них STEP 7 5.3 SP1

j0rdan · Post by **j0rdan** » Wed Mar 05, 2008 7:11 am

I am with STE7 5.4 and everything work just fine with the speedbus but i have some problems with my can interface i still don't know where the bits from the vipa configuration tool going to the VIPA plc if someone have some experience with that please contact me.

And if someone have a contact of their support please give it to me, because i have some problems with the support in my country.

ICQ: 218458734
e-mail: v.prezhdarov@gmail.com

Umencho · Post by **Umencho** » Wed Mar 05, 2008 8:23 am

Hi Jordan

... And if someone have a contact of their support please give it to me, because i have some problems with the support in my country.

See here: http://www.vipa.de/en/service/

Regards
Umencho

j0rdan · Post by **j0rdan** » Mon Mar 10, 2008 8:25 am

Hi Umencho,
I send them message before three weeks and still no answer i ask for some more inside support mail because i really need some info about that.
Regards
J0rdan.

j0rdan · Post by **j0rdan** » Mon Mar 10, 2008 1:26 pm

the hotline in Bulgaria don't know what to do they don't know anything about the CAN interface

Janis · Post by **Janis** » Mon Mar 10, 2008 2:46 pm

Better call them on hotline.
Call Germany:

Hotline +49 (0) 9132 - 744 - 114
Hotline (Mobile): +49 (0) 172 - 8248373