[?]: How connect cp343-1 s-7 300 cpu314-2dp

amet · Post by **amet** » Wed Aug 08, 2007 8:53 am

ethernet:cp343-1 v1.2 plc:s-7 300 cpu314-2dp i want connect pc and plc use ethernet protocol. plc ıp:140.80.0 2 pc ip:140.80.0.4 but no connected.

thanks.

DimonS · Post by **DimonS** » Wed Aug 08, 2007 12:10 pm

at first upload project via MPI

amet · Post by **amet** » Wed Aug 08, 2007 2:14 pm

ok upload project
Ethernet(1)
interface:cp343-1
ip adres:140.80.0.2

now?

DimonS · Post by **DimonS** » Wed Aug 08, 2007 2:48 pm

into PC/PG Interface set the ethernet protocol

amet · Post by **amet** » Thu Aug 09, 2007 5:07 am

PG/PC İnterface:
i set TCP/IP-->PRO/100 VE Ne.......

DimonS · Post by **DimonS** » Thu Aug 09, 2007 11:43 am

Using the Ping command you can test whether an Ethernet connection can be set up between the PG/PC and the S7 controller or the CP343-1.

Open an MSDOS prompt ("Start > Run > cmd").
Enter the "ping" command and the IP address of the S7 controller - e.g. "ping 140.80.0.2".
The S7 controller is then accessible via Industrial Ethernet when reply messages are sent in response to the ping request.

amet · Post by **amet** » Thu Aug 09, 2007 11:47 am

Sorry. I use ethernet cable , I need cross ethernet cable.
Thanks a lot.

--------------------------------------------------
Ethernet PC<-->PC cable ("NULL-Hub" or "cross-over")

or

-------- PC<--> HUB -----------------
identical

or

-----------------------------