[?]: FBD partially converts to STL

[MikeMMM]

When open FBD project i view it in STL

Посоветуйте, как решить проблему: при переносе Step7 проекта с одного компьютера на другой некоторые нетворки из FBD преобразуются в STL.
Версии Step7 и Windows на обоих компьютерах одинаковые.

[indian]

I'm stumped, please give me an advise: after transferring a project to another PC some FBD networks somehow had been partially converted to STL. Installed software are the same on both PC.

You have to make this networks simplier by editing them in STL.

[slp530]

When in the LAD/STL/FDB editor, go to Options >> Customise >> LAD/FDB window and turn off the "Type check of Addresses". please note if you make any errors with data tyes they will not be highlighted.