PLCforum.uz.ua

Posted: **Sat Jan 28, 2012 12:33 am**

Can somebody download this tool from here?
http://support.automation.siemens.com/W ... n/19440762

Primary Setup Tool (PST) version 4.1 for Windows 7 (32/64 Bit) enables you to perform address allocations (e.g. IP address) for SIMATIC NET network components, Ethernet CPs and gateways.

The precondition is that these SIMATIC NET devices have a preset ETHERNET (MAC) address and are accessible on-line in the network.

Remark:
The address setting can also be done with STEP 7 (see STEP7 documentation). In the near future it will be possible to perform more address settings for SIMATIC NET Ethernet products via PST Tool and STEP 7.

Posted: **Sat Jan 28, 2012 5:52 am**

Yes, link is correct. I can. What is the situation in your case?

Posted: **Sat Jan 28, 2012 6:33 am**

PST Tool 4.1 for Windows 32/64
https://support.automation.siemens.com/ ... ST_V41.zip

Posted: **Sat Jan 28, 2012 6:45 pm**

Link
Thank you very much.

Umencho
I'm working under Windows 7, so all previous PST versions didn't work.

Posted: **Sun May 01, 2016 2:59 pm**

Hi

If someone could throw again active link to PST?

Thanks a lot

Posted: **Sun May 01, 2016 5:12 pm**

SIMATIC Automation Tool
https://support.industry.siemens.com/cs ... n&lc=ru-RU

Posted: **Thu May 05, 2016 10:50 am**

CoMod wrote:SIMATIC Automation Tool
https://support.industry.siemens.com/cs ... n&lc=ru-RU

But This is not this (PRIMARY SETUP TOOL) program...

Posted: **Tue Aug 09, 2016 6:24 am**

Now, can use Proneta v2.2, this sofeware can define device ip & name, display topology and so on~~

PLCforum.uz.ua

[LINK]: PST Tool 4.1

[LINK]: PST Tool 4.1

Re: [Request] PST Tool 4.1

PST Tool 4.1

Re: [LINK]: PST Tool 4.1

Re: [LINK]: PST Tool 4.1

Re: [LINK]: PST Tool 4.1

Re: [LINK]: PST Tool 4.1

Re: [LINK]: PST Tool 4.1