[LINK]: PST Tool 4.1

SIMATIC S7-200/300/400, Step7, PCS7, CFC, SFC, PDM, PLCSIM,
SCL, Graph, SPS-VISU S5/S7, IBHsoftec, LOGO ...
Post Reply
Rex2701
Posts: 267
Joined: Wed Oct 13, 2010 8:44 am
Location: Russian Federation

[LINK]: PST Tool 4.1

Post by Rex2701 » Sat Jan 28, 2012 12:33 am

Can somebody download this tool from here?
http://support.automation.siemens.com/W ... n/19440762
Primary Setup Tool (PST) version 4.1 for Windows 7 (32/64 Bit) enables you to perform address allocations (e.g. IP address) for SIMATIC NET network components, Ethernet CPs and gateways.

The precondition is that these SIMATIC NET devices have a preset ETHERNET (MAC) address and are accessible on-line in the network.

Remark:
The address setting can also be done with STEP 7 (see STEP7 documentation). In the near future it will be possible to perform more address settings for SIMATIC NET Ethernet products via PST Tool and STEP 7.

Umencho
Posts: 497
Joined: Mon Jul 16, 2007 12:28 pm
Location: Europe

Re: [Request] PST Tool 4.1

Post by Umencho » Sat Jan 28, 2012 5:52 am

Yes, link is correct. I can. What is the situation in your case?

Link
Forum Community
Forum Community
Posts: 1088
Joined: Fri Oct 20, 2006 9:29 pm
Location: We are anonymous users. We do not read your private messages :( Ask questions in the forum !
Contact:

PST Tool 4.1

Post by Link » Sat Jan 28, 2012 6:33 am


Rex2701
Posts: 267
Joined: Wed Oct 13, 2010 8:44 am
Location: Russian Federation

Re: [LINK]: PST Tool 4.1

Post by Rex2701 » Sat Jan 28, 2012 6:45 pm

Link
Thank you very much.

Umencho
I'm working under Windows 7, so all previous PST versions didn't work.

czajot
Posts: 2
Joined: Tue Apr 19, 2016 12:42 pm

Re: [LINK]: PST Tool 4.1

Post by czajot » Sun May 01, 2016 2:59 pm

Hi

If someone could throw again active link to PST?

Thanks a lot

CoMod
Site Admin
Posts: 3561
Joined: Thu Feb 16, 2006 3:25 pm
Location: Russia
Contact:

Re: [LINK]: PST Tool 4.1

Post by CoMod » Sun May 01, 2016 5:12 pm


czajot
Posts: 2
Joined: Tue Apr 19, 2016 12:42 pm

Re: [LINK]: PST Tool 4.1

Post by czajot » Thu May 05, 2016 10:50 am

CoMod wrote:SIMATIC Automation Tool
https://support.industry.siemens.com/cs ... n&lc=ru-RU
But This is not this (PRIMARY SETUP TOOL) program...

potato_hxh
Posts: 3
Joined: Tue Aug 09, 2016 6:03 am

Re: [LINK]: PST Tool 4.1

Post by potato_hxh » Tue Aug 09, 2016 6:24 am

Now, can use Proneta v2.2, this sofeware can define device ip & name, display topology and so on~~

Post Reply