[?]: Which devices and modules are supported by STEP 7 ?

SIMATIC S7-200/300/400, Step7, PCS7, CFC, SFC, PDM, PLCSIM,
SCL, Graph, SPS-VISU S5/S7, IBHsoftec, LOGO ...
Post Reply
maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

[?]: Which devices and modules are supported by STEP 7 ?

Post by maher » Wed Jan 04, 2012 8:46 am

Hi all

if I have plc s7-414H the version for the software is v5.4 sp5, but I have software ver5.5,
if I upload by this version it will have any bad effect or not?

best regards,
Maher

Info
Faq & Info
Faq & Info
Posts: 425
Joined: Wed Oct 05, 2005 9:00 am

Re: [?]: simatic software and hardware versions

Post by Info » Wed Jan 04, 2012 9:14 am

You can use new software Step7 5.5 SP* with old hardware without problems.
You can use some new hardware (not all) with old Step7 5.* - but with some problems and restrictions. For PN is prerequired Step7 5.5 SP*.
The new CPUs can be programmed with STEP 7 V5.* + SP* and higher and Hardware Update HSP (Hardware Support Package).
You can download the Hardware Update with STEP7 via the Internet http://support.automation.siemens.com/W ... n/23183356
or Use the command Extras -> Install HW Updates under STEP7 -> Configure Hardware for this purpose.
For Step7 v11 - you can use hardware from STEP7_V11_Support_HW_List.pdf only
(sfaq) Which devices and modules are supported by STEP 7 Professional V11 and WinCC Professional V11?
https://support.automation.siemens.com/ ... W_List.pdf


(sdoc) SIMATIC High-availability systems S7-400H doc
http://support.automation.siemens.com/W ... n/53385282

Post Reply