[?]: Access to the IMSR modules

SIMATIC S7-200/300/400, Step7, PCS7, CFC, SFC, PDM, PLCSIM,
SCL, Graph, SPS-VISU S5/S7, IBHsoftec, LOGO ...
Post Reply
maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

[?]: Access to the IMSR modules

Post by maher » Wed Jun 15, 2011 6:18 am

Hi all
I cann't access to the modules ( when I entered to H.W iI found cross on the modules ?????
so what is the reasons for that ?
Also I have image but i cann't upload it to here,could you tell me how can I make this ?
Image
Regards,
Maher

PLC_ITA
Posts: 263
Joined: Sat May 27, 2006 6:46 am
Location: Europe

Re: [?]: Access to the IMSR modules

Post by PLC_ITA » Thu Jun 16, 2011 8:49 pm

(not_allow)

stay quiet !

here there are people that work for all GRATIS ! You cannot require an answer after 6 hours !!

Check if the hardware code is correct. If is correct recompile and download the hardware config

peterc101
Posts: 34
Joined: Mon Oct 11, 2010 12:54 pm

Re: [?]: Access to the IMSR modules

Post by peterc101 » Thu Jun 16, 2011 10:08 pm

PLC_ITA is right you got a wrong harware configuration or you just forgot to download it

maher
Posts: 112
Joined: Fri Aug 29, 2008 8:44 pm
Location: Egypt

Re: [?]: Access to the IMSR modules

Post by maher » Sat Jun 18, 2011 9:48 am

PLC_ITA wrote: (not_allow)

stay quiet !

here there are people that work for all GRATIS ! You cannot require an answer after 6 hours !!

Check if the hardware code is correct. If is correct recompile and download the hardware config

but i had got this problem after I uploading the program, so is it right to download again what I uploaded after ( save & compiling ) process

Maher

Post Reply