PLCforum.uz.ua

Hello

I know there was thread on mrplc.com but this site is down and can't find it elswhere .
I get message:

"blockversion is newer version and cannot be uploaded"

when in english

CPU 224CN REL 02.01

I use Microwin 4.0.7.10 given on this site here. When I switch to chinese i have everywhere "?????" ,
I turned chinese signs in windows xp, switched language to chinese.
So , when I switch to chinese in Microwin, microwin hangs and closes.

I'm at customer and I can try tomoorow morning polish time .
I cracked password from 24c256 EEPROM, it was easy, and password works of course .
Could anyone help me please?
I know I'm almost there but can't figure it out.

Upload to chinese version of S7-200CN
1. Select Chinese langauge and close MicroWin
2. Folder Bin: Copy english resource file ResB.dll to ResK.dll (Replace chinese resource file resk.dll)

Для загрузки-выгрузки програмного кода в контроллеры с суффиксом "CN"(китай) выставляем язык китайский,если не устраивают знаки вопроса???? переименовываем файл русификации ResB.dll в resk.dll заменяем аналогичный в папке Bin.

ok, thanks but now i got everywhere "traqnslation required" in microwin....

OK, i 've changed to chinese and now there is in english, is it enough? tomorrow I have last chance to read program

NEED HELP!!!! Microwin hangs, I have only half hour and I must go!!!!