PLCforum.uz.ua

Hi Guys, I wanted to install winCC Unified, however, while installation I got this(picture below). IT is blank, and I can not put a stick to it… I also tried to install manually, however it is not allowed.. OS is an updated Windows 10... Any idea? I have downloaded the files from Siemens page and tr...

company, router policy can block it also. Norton intelligent file protection also blocks it.

I got the same problem, about 2 weeks ago, but in the end: Nothing magic stuff like anything for S7-200, so need to wait too much, an in the end nothing is guaranteed.

If it is TIA, it protected via 2048 bit RSA... Forget that.

If it is simatic manager based: In links topic maybe you will find something.

Easiest way: Use virtual clone drive. Freeware. (gogle) After install the simulator(if you have) Install the wincc (if you have) Then install TIA Portal. I advise you to install the service pack. After you installed, the TIA portal will faster, and there are less bugs. Less freezing. Best Regards, A...

Dear Everyone, I have a little problem, with winCC time format. I have some timer, and i want to modify the "PT"(preset time). The timers in an FB, and what i want: I want to modify it from HMi, but not in secunduns. (for example we have timer whick value is 96 Hour.. so secundum is not the best sol...

http://www27.zippyshare.com/v/51929292/file.html

Use it
Greetings from Hungary

Dear Everyone, I need a S7-200 programming port pinout. I have an USB-RS232 with driver, and an RS232 to RS485 physical device(no need driver). My question is: Which is the 2pins, or 3(if i must use GND), that i need for programming. I find in google: R/D + is 3. GND is 5. R/D - is 8. Is it correct?